- This topic has 0 replies, 1 voice, and was last updated 7 years, 1 month ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Once the clothes have been fitted and you're ready to decimate the meshes, make sure you turn off enable smoothing in the parameters tab. Do this for each bit of clothing.
This will let you decimate to a much lower poly count without getting the poke through (especially useful for tight fitting clothing).
Using this method you can take a 500k poly character down to 50-70k polygons without losing much detail.
The decimator is most noticeable on skin so I try to keep the skin of the character closer to 100% undecimated and just focus on optimizing the clothings.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
