How do I fix this.

[otrofulano]

Hello, Noob here.

I've been having some problems with DAZ figures and some poses.

sometimes I get this sort of deformation and need help on how to fix it.

https://simp3.jpg.church/images/Screen-Shot-2022-06-13-at-12.14.48-PM.jpg

I've tried to adjust the rigging to the shape method, align bones, etc. but no luck.

unfortunately, there's not much documentation online.

[oldspokesy]

I've ran into this a few times. You're going to need to go to paramiters and dig through the "currently used" morphs- one or more will either be jacked up to 100 or down to 0. Make sure to show hidden.
Last time it was a Mervin morph and before that a Hippoman morph. Good luck!

[otrofulano]

thanks for the prompt response.

I tried something similar before and opted to create a full character morph via morphloader onto a new gen 8.1 figure.

results were the same.

I'll give another try to your solution.

thanks again.

[oldspokesy]

Here's where I was struggling- link
The one that was messing me up actually turned out to be 2 different character "fixes" for "shinbend" so, check there too.

[Frank21]

I'm having the same problem with one of my characters. Thanks for the tip about corrective morphs @Oldspokesy.

[Mikoudelsanpedro]

hello !

how did you mesh you're character ?

Best regard's

[oldspokesy]

@frank21 , no problem. I thought about adding that since I remembered passing it up a few times because those are sort of grey and dont stand out when you're scrolling through.

[Author]

Posts