Genesis Generation X2 help Home Page › Forums › General Chat › Genesis Generation X2 help This topic has 4 replies, 2 voices, and was last updated 6 years, 6 months ago by Angel_twins. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts October 21, 2017 at 9:22 pm #368255 Angel_twinsParticipant Rank: I downloaded GX2 here and want to convert V4 morphs but there is no V4 figure at "source" and when I drag the V4 figure into the window it says C:/DAZ3D/Content/Runtime/Geometries/DAZPeople/blMilWom_v4b.obj Poser figure not supported. Source only shows G2 and G3 how can I fix this? October 21, 2017 at 9:32 pm #368270 eelgooModerator Rank: There is a base program exe & there is an add on which takes the conversion to G2F & there is another add on which takes it to G3F. I suspect you may have installed one of the add ons rather than the base program? :0/ October 21, 2017 at 9:42 pm #368278 Angel_twinsParticipant Rank: No I did install this one "https://zonegfx.com/genesis-generation-x2/" if this is the base program. *I just installed it again just to make sure but its still the same issue.* October 21, 2017 at 10:45 pm #368322 eelgooModerator Rank: Try dragging it across to the GenX panel rather than into the main window? :0/ October 21, 2017 at 11:13 pm #368342 Angel_twinsParticipant Rank: No it dosen't work no matter where I drag it. I think there is something wrong with my V4. I will try it again on a diffrent pc with a clean daz3d tomorrow Author Posts Viewing 5 posts - 1 through 5 (of 5 total) You must be logged in to reply to this topic. Log In Username: Password: Keep me signed in Log In